百口泉地下水电导率与溶解性总固体相关性讨论

由于溶解性总固体的测定较为复杂,平行性、稳定性差,而电导率的测定简便、迅速,重现性、稳定性好,若二者相关关系显著,可通过测定电导率,按一定的比例推算水中溶解性总固体的量。通过对百口泉地下水的溶解性总固体与电导率的相关性的监测、分析,经统计检验,线性关系显著,其比值范围在065～076,均值为07,即百口泉地下水的电导率1μs/cm相当于070mg/L的溶解性总固体。     

Present status of the recycling of waste electrical and electronic equipment in Korea

In Korea due to rapid economical growth followed by urbanisation, breakage of large traditional families into small nuclear families, continuous changes in equipment features and capabilities causes tremendous increase in sale of new electrical and electronic equipment (EEE) and decrease in sale of used EEE. Subsequently, the ever-increasing quantity of waste electrical and electronic equipment (WEEE) has become a serious social problem and threat to the environment. Therefore, the gradual increase in the generation of WEEE intensifies the interest for recycling to conserve the resources and protect the environment. In view of the above, a review has been made related to the present status of the recycling of waste electrical and electronic equipment in Korea. This paper describes the present status of generation and recycling of waste electrical and electronic equipment, namely TVs, refrigerators, washing machines, air conditioners, personal computers and mobile phones in Korea. The commercial processes and the status of developing new technologies for the recycling of metallic values from waste printed circuit boards (PCBs) is also described briefly. Since 1998, three recycling centers are in full operation to recycle WEEE such as refrigerators, washing machines and air conditioners, having the total capacity of 880,000 units/year. All waste TVs are recently recycled on commission basis by several private recycling plants. The recycling of waste personal computers and mobile phones is insignificant in comparison with the amount of estimated obsolete those. Korea has adopted and enforced the extended producer responsibility (EPR) system. Korea is making consistent efforts to improve the recycling rate to the standards indicated in the EU directives for WEEE. Especially environmentally friendly and energy-saving technologies are being developed to recycle metal values from PCBs of WEEE.     

Toxicological characterization of the landfill leachate prior/after chemical and electrochemical treatment: A study on human and plant cells

In this research, toxicological safety of two newly developed methods for the treatment of landfill leachate from the Piškornica (Croatia) sanitary landfill was investigated. Chemical treatment procedure combined chemical precipitation with CaO followed by coagulation with ferric chloride and final adsorption by clinoptilolite. Electrochemical treatment approach included pretreatment with ozone followed by electrooxidation/electrocoagulation and final polishing by microwave irradiation. Cell viability of untreated/treated landfill leachate was examined using fluorescence microscopy. Cytotoxic effect of the original leachate was obtained for both exposure periods (4 and 24 h) while treated samples showed no cytotoxic effect even after prolonged exposure time. The potential DNA damage of the untreated/treated landfill leachate was evaluated by the comet assay and cytokinesis-block micronucleus (CBMN) assay using either human or plant cells. The original leachate exhibited significantly higher comet assay parameters compared to negative control after 24 h exposure. On the contrary, there was no significant difference between negative control and chemically/electrochemically treated leachate for any of the parameters tested. There was also no significant increase in either CBMN assay parameter compared to the negative control following the exposure of the lymphocytes to the chemically or electrochemically treated landfill leachate for both exposure periods while the original sample showed significantly higher number of micronuclei, nucleoplasmic bridges and nuclear buds for both exposure times. Results suggest that both methods are suitable for the treatment of such complex waste effluent due to high removal efficiency of all measured parameters and toxicological safety of the treated effluent.     

Contaminant degradation in physically and chemically heterogeneous aquifers

This paper examines the importance of the correlation between hydraulic conductivity (K) and degradation rate constant (k) during the transport of reactive contaminants in heterogeneous aquifers. We simulated reactive transport in an ensemble of two-dimensional heterogeneous aquifers. Two sets of transport simulations were conducted: one in which a perfect positive correlation was assumed between ln(K) and ln(k), and one in which a perfect negative correlation was assumed. We found that the sign of the correlation has important consequences for the contaminant transport. Qualitatively, a negative correlation leads to significantly more pronounced "fingering" of the contaminant plume than does a positive correlation, with potentially important consequences for downgradient receptors. Quantitatively, the expected behavior (as quantified by the contaminant mass remaining in the aquifer) is statistically different between the positive and negative cases: on average, more contaminant mass persists when K and k are negatively correlated. Also, the negative correlation leads to more variability between realizations of the ensemble, whereas a positive correlation induces relatively little variability between realizations. We discuss the implications of these findings for the management of contaminated aquifers.     

实验室环境温度下电导率测定计算的改进

对原电导率温度校正公式进行了改进，改进后的校正公式在实验室环境温度（11－30℃）下较适用。     

A comparison of the low frequency electrical signatures of iron oxide versus calcite precipitation in granular zero valent iron columns

Geophysical methods have been proposed as technologies for non-invasively monitoring geochemical alteration in permeable reactive barriers (PRBs). We conducted column experiments to investigate the effect of mineralogy on the electrical signatures resulting from iron corrosion and mineral precipitation in Fe0 columns using (a) Na2SO4, and (b) NaHCO3 plus CaCl2 mixture, solutions. At the influent interface where the reactions were most severe, a contrasting time-lapse electrical response was observed between the two columns. Solid phase analysis confirmed the formation of corrosion halos and increased mineralogical complexity in the corroded sections of the columns compared to the minimal/non-corroded sections. We attribute the contrasting time-lapse signatures to the differences in the electrical properties of the mineral phases formed within the two columns. While newly precipitated/transformed polarizable and semi-conductive iron oxides (mostly magnetite and green rust) increase the polarization and conductivity of the sulfate column, the decrease of both parameters in the bicarbonate column is attributed to the precipitation of non-polarizable and non-conductive calcite. Our results show that precipitate mineralogy is an important factor influencing the electrical properties of the corroded iron cores and must be considered if electrical geophysical methods are to be developed to monitor PRB barrier corrosion processes in situ.     

QuEChERS: a sample preparation for extraction of carbaryl from rat feces

Carbamate compounds are an important group of cholinesterase inhibitors. There is a need for creating awareness regarding the risks of the inadequate carbamate use in the residential areas due to potential adverse human effects. Carbaryl is a commonly used pesticide worldwide. A simple, fast, and high-throughput method was developed employing liquid chromatography with fluorescence detector to determine carbaryl residues in rat feces. The extraction was performed by using a rapid, easy, cheap, effective, reliable, and safe (QuEChERS) method, using acetonitrile as the extracting solvent. The parameters for the performance of the extraction method were optimized, such as ratio of mass of sample per volume of extraction solvent, QuEChERS content, and cleanup columns. Linear response was obtained for all calibration curves (solvent and matrix-matched) over the established concentration range (5–500 μg/L) with a correlation coefficients higher than 0.999. The achieved recovery was 97.9% with relative standard deviation values of 1.1% (n = 4) at 167 μg/kg fortified concentration level and the limits of detection and quantification were 27.7 and 92.3 µg/kg, respectively.     

基于野外数据建立大型底栖动物电导率水质基准的可行性探讨

科学合理地设定水质基准是水生生物保护和水生态系统恢复的基础。水体电导率数值的高低由溶解于其中的各种阴阳离子的浓度所决定,而较多的研究也证明电导率能够显著地影响水生生物类群,特别是大型底栖动物物种存活和群落结构的稳定性。离子组成的复杂性,导致无法开展基于室内实验的水生生物电导率基准值的推导。本文借鉴美国环境保护局基于野外调查数据建立电导率基准值的方法,采用流行病学打分方法,分别从电导率是否对大型底栖动物敏感物种存在毒性效应、人为干扰的增强是否会通过电导率产生毒性作用,以及其他环境因子是否对电导率基准值的制定产生影响3个方面,探讨了基于野外数据建立我国电导率基准的可行性。研究区域为辽河流域的浑河及太子河,野外调查数据采集于2009年8月至2010年5月。研究结果表明,电导率的升高显著降低了大型底栖动物敏感物种的出现频率。通过分析研究区域土地利用方式同电导率之间的相关性,证明了农业和城镇建设用地比例的增加显著地增加了水体中电导率的数值。对有可能引起物种消失的其他环境因子进行分析,结果表明电导率是引起大型底栖动物消失的主要原因。综合以上结果,基于野外调查数据来建立大型底栖动物电导率基准值是可行的,为我国水质基准的研究提供了新的思路和方法。     

SiO2气凝胶隔热性能的影响因素研究

目的 在不同热流条件下,通过调整SiO2气凝胶的孔隙率、涂层厚度等,以满足合适的隔热要求。方法 针对中短程飞行器飞行时外壁面承受短时高热流的特点,在分析孔隙率对SiO2气凝胶热导率影响规律的基础上,通过数值仿真研究不同气凝胶孔隙率、气凝胶厚度及热流作用下的温度响应。结果 得到了不同条件下满足隔热要求的气凝胶最小厚度,以及气凝胶表面的最高温度。高温情况下,气凝胶孔隙率为96%时,有效热导率最低,孔隙率超过96%时,隔热性能变差。结论 当飞行器内壁面温度满足要求时,增大气凝胶的孔隙率,则需要减小气凝胶的厚度,相应的气凝胶表面温度会升高,但升幅很小。当飞行器外壁面承受长时间大热流时,仅调整气凝胶的厚度和孔隙率不能达到结构的隔热要求。     

聚合反应时间对聚酰亚胺基碳膜结构和性能的影响研究

目的 系统研究前驱体聚合反应时间对PI膜及其碳化、石墨化后薄膜结构和性能的影响规律。方法 通过调整聚合合成聚酰胺酸(PAA)溶液过程中的反应时间,制备石墨膜前驱体聚酰亚胺(PI)原膜,将不同工艺条件下制得的PI膜进行碳化、石墨化处理,得到高导热率石墨膜。利用扫描电镜、红外光谱、拉曼光谱仪和LFA激光闪射仪对制备的PI膜、碳化膜及石墨膜的微观结构和热导率进行检测。结果 随聚合反应时间的延长,PI膜酰亚胺化程度和石墨膜的石墨化程度及导热性能先增高、后降低。反应时间为3 h时,制得的石墨膜结构致密,石墨片层取向性好,导热性能最好,热导率可达765.2 W/(m.K)。结论 PI膜前驱体聚合反应时间显著影响PI膜酰亚胺化的程度和有序度,进而影响石墨膜的定向性和导热性能。